| • |
Universal FTA receiver that can be flashed to become a
Pansat 2500A or Fortec Lifetime Ultra Receiver |
| • |
Comes with a Pansat and Fortec compatible remote, and FREE serial
cable so you can control your unit with either flash |
| • |
Once flashed, there will be no difference in
performance, interface, or functionality |
| • |
Lower cost than a Pansat or Fortec |
| • |
Comes with exclusive FTAWorld hardware warranty |
| • |
30% smaller than the Fortec or Pansat |
| • |
S-Video Output for superior picture quality |
| TUNER & DEMODULATOR |
| Input Connector |
F-Type female IEC169-24 |
| Frequency Range |
950 - 2150 MHz |
| Demodulation |
QPSK |
| Symbol Rate |
2-45 Msps |
| Input Level |
-65 dBm ~ 25dBm |
| Input Impedance |
75 ohms |
| LNB Power |
13/18 V DC, Max. 500 mA |
| DiSEqC Control |
Version 1.3 Compartible |
| Band Switching |
22 KHz Tone |
| Viterbi Decoding Rate |
1, 2/3, 3/4,5/6,7/8 |
| MPEG TRANSPORT STREAM & A/V DECODING |
| Transport Stream |
MPEG-2 ISO/IEC 138-18-1 |
| Input Rate |
Max. 90 Mbit/s |
| Video |
MPEG-2 MP@ML |
| Video Resolution |
Max. 720 x 480 |
| Aspect Ratio |
4:3 - Normal TV, 16:9 Wide TV |
| Audio Decoding |
MPEG-1/2 Audio Layer I & II |
| Audio Mode |
Single/Dual Channel, Stereo, Joint Stereo |
| MICROPROCESSOR & MEMORIES |
| Main Processor |
STi5518 (ST2D 32 bit, 81 MHz) |
| Flash Memory |
2 Mbyte |
| SDRAM |
8 Mbyte |
| CPU Clock |
81 MHz |
| EEPROM |
32 Kbit |
| RF MODULATOR |
| PLL type |
Ch 21-69 for the modulation |
| RF Connector |
75 Ohm, 169 - 2, Male/ Female |
| TV Standard |
PAL B/G, I, SECAM L, NTSC M selectable |
| Frequency Range |
UHF:470~860 MHz |
| A/V & Data OUTPUT/INPUT |
| IF Input |
IEC1692 Male/Female |
| IF Loop-through Output |
1 x F type |
| RCA Jack |
CVBS Audio L, R 0/12 DC out |
| Serial Port |
RS-232C Bound Rate 115200, 9 Pin D-Sub |
| POWER SUPPLY/MECHANICAL POLARIZER |
| Input |
AC 80 - 260V, 50/60 Hz |
| Power Consumption |
Max. 25W |
| GENERAL DATA |
| Unit Dimension(mm) |
290 x 200 x 65 |
| Unit Weight |
2.3 Kg |
Any 3rd party software loaded/used which is not supported by the
manufacturer, will void the equipment manufacturer's warranty. Note that the
software may be incompatible across various models. If you upload the wrong
software and create a problem with the receiver, this will not only void
your warranty, it may make your receiver inoperable. It may also require
service which is not covered under the warranty. File transfers errors are
entirely your responsibility, and we are not responsible for any receivers
problems as a result of that.
